How To Re-ink An Xstamper Pre-inked Stamp

In this video, Daniel Jackson, VP of Customer Service at Simply Stamps demonstrates the proper way to re-ink a Xstamper pre-inked stamp.

Here’s a transcript of the video:

Your refill ink is going to come in the box, you’ll simply open the box, and remove the ink.

You will then take the Xstamper and remove the cap off the top. In the stamp, there are two portals where we’ll put the ink. So you only need a couple of ink drops in each section.

You’ll put the cap back on the stamp. And you’re done!

The ink needs to settle for about twenty-four hours for it to fully get through the pad itself.

For any additional information, or for refill inks, or additional help – visit

Reinking your pre-inked stamp only needs 4 easy steps.

  1. Remove cap of our pre-inked stamp
  2. Drip a couple drops in each of the two holes
  3. Replace the cap
  4. Let sit for 24 hours to allow ink to fully soak into the stamp pad


Leave a Reply

Your email address will not be published.